burst_size - (Optional) Specifies the burst size for the single rate two color mode. The unit is
Kbytes.
<value 1-262144> - Enter the burst size value here. This value must be between 1 and
262144.
rate_exceed - Specifies the action for packets that exceeds the committed rate in single rate,
two color mode.
drop_packet - Drops the packet immediately.
remark_dscp - Marks the packet with a specified DSCP. The packet is set to have a high
drop precedence.
<value 0-63> - Enter the remark DSCP value here. This value must be between 0 and
cir - Specifies the Committed Information Rate. The unit is in Kbps. CIR should always be
equal or less than PIR.
<value 1-1048576> - Enter the commited information rate value here. This value must be
between 1 and 1048576.
cbs - (Optional) Specifies the “Committed Burst Size”. The unit is Kbytes. That is to say, 1
means 1Kbytes. This parameter is an optional parameter. The default value is 4*1024.
<value 1-262144> - Enter the commited burst size value here. This value must be between
1 and 262144.
pir - Specifies the “Peak Information Rate”. The unit is in Kbps. PIR should always be equal to
or greater than CIR.
<value 1-1048576> - Enter the peak information rate value here. This value must be
between 1 and 1048576.
pbs - (Optional) Specifies the “Peak Burst Size”. The unit is in Kbytes. This parameter is an
optional parameter. The default value is 4*1024.
<value 1-262144> - Enter the peak burst size value here. This value must be between 1
and 262144.
color_blind - (Optional) Specifies the meter mode as color-blind. The default is color-blind
mode.
color_aware - (Optional) Specifies the meter mode as color-aware. The final color of the
packet is determined by the initial color of the packet and the metering result.
conform - (Optional) Specifies the action when a packet is mapped to the “green” color.
permit - Permits the packet.
replace_dscp - Changes the DSCP of the packet.
<value 0-63> - Enter the replace DSCP value here. This value must be between 0 and
63.
counter - (Optional) Specifies the ACL counter. This is optional. The default is “disable”.
The resource may be limited so that a counter cannot be turned on. Counters will be
cleared when the function is disabled.
enable - Specifies that the ACL counter option will be enabled.
disable - Specifies that the ACL counter option will be disabled.
exceed - Specifies the action when a packet is mapped to the “yellow” color.
permit - Permits the packet.
replace_dscp - (Optional) Changes the DSCP of the packet.
<value 0-63> - Enter the replace DSCP value here. This value must be between 0 and
63.
drop - Drops the packet.
counter - (Optional) Specifies the ACL counter. This is optional. The default is “disable”.
The resource may be limited so that a counter cannot be turned on. Counters will be
cleared when the function is disabled.
enable - Enables the ACL counter option.
disable - Disables the ACL counter option.
violate - Specifies the action when a packet is mapped to the “red” color.
permit - Permits the packet.
replace_dscp - (Optional) Changes the DSCP of the packet.
<value 0-63> - Enter the replace DSCP value here. This value must be between 0 and
63.
To Next Page
Loading...
