D-Link DGS-3000 series - Page 101

DGS-3000 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
97
counter - (Optional) Specifies the ACL counter. This is optional. The default is disable. The
resource may be limited so that a counter cannot be turned on. Counters will be cleared
when the function is disabled.
enable - Specifies that the ACL counter option will be enabled.
disable - Specifies that the ACL counter option will be disabled.
sr_tcm - Specifies “single rate three color mode”.
cir - Specifies the ommitted Information Rate. The unit is Kbps.
<value 0-1048576> - Enter the comitted information rate value here. This value must be
between 0 and 1048576.
cbs - Specifies the “Committed Burst Size” The unit is Kbytes.
<value 0-131072> - Enter the commited burst size value here. This value must be between
0 and 131072.
ebs - Specifies the “Excess Burst Size”. The unit is Kbytes.
<value 0-131072> - Enter the excess burst size value here. This value must be between 0
and 131072.
color_blind - (Optional) Specifies the meter mode as color-blind. The default is color-blind
mode.
color_aware - (Optional) Specifies the meter mode as color-aware. The final color of the
packet is determined by the initial color of the packet and the metering result.
conform - (Optional) Specifies the action when a packet is mapped to the “green” color.
permit - Permits the packet.
replace_dscp - Changes the DSCP of the packet.
<value 0-63> - Enter the replace DSCP value here. This value must be between 0 and
63.
counter - (Optional) Specifies the ACL counter. This is optional. The default is “disable”.
The resource may be limited so that a counter cannot be turned on. Counters will be
cleared when the function is disabled.
enable - Enables the ACL counter option.
disable - Disables the ACL counter option.
exceed - Specifies the action when a packet is mapped to the “yellow” color.
permit - Permits the packet.
replace_dscp - (Optional) Changes the DSCP of the packet.
<value 0-63> - Enter the replace DSCP value here. This value must be between 0 and
63.
drop - Drops the packet.
counter - (Optional) Specifies the ACL counter. This is optional. The default is “disable”.
The resource may be limited so that a counter cannot be turned on. Counters will be
cleared when the function is disabled.
enable - Enables the ACL counter option.
disable - Disables the ACL counter option.
violate - Specifies the action when a packet is mapped to the “red” color.
permit - Permits the packet.
replace_dscp - (Optional) Changes the DSCP of the packet.
<value 0-63> - Enter the replace DSCP value here. This value must be between 0 and
63.
drop - Drops the packet.
counter - (Optional) Specifies the ACL counter. This is optional. The default is disable. The
resource may be limited so that a counter cannot be turned on. Counters will be cleared
when the function is disabled.
enable - Enables the ACL counter option.
disable - Disables the ACL counter option.
delete - Deletes the specified flow_meter.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.