D-Link DGS-3000 series - Show Switch

DGS-3000 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
117
10-5 show switch
Description
This command is used to display the Switch information.
Format
show switch
Parameters
None.
Restrictions
None.
Example
The following is an example for display of the Switch information.
DGS-3000-26TC:admin#show sw
Command: show switch
Device Type : DGS-3000-26TC Gigabit Ethernet Switch
MAC Address : 00-01-02-03-04-00
IP Address : 10.90.90.90 (Manual)
VLAN Name : default
Subnet Mask : 255.0.0.0
Default Gateway : 0.0.0.0
Boot PROM Version : Build 1.00.001
Firmware Version : Build 1.00.015
Hardware Version : A1
System Name :
System Location :
System Uptime : 0 days, 2 hours, 2 minutes, 52 seconds
System Contact :
Spanning Tree : Disabled
GVRP : Disabled
IGMP Snooping : Disabled
MLD Snooping : Disabled
VLAN Trunk : Disabled
Telnet : Enabled (TCP 23)
Web : Enabled (TCP 80)
SNMP : Disabled
SSL Status : Disabled
CTRL+C ESC q Quit SPACE n Next Page ENTER Next Entry a All