D-Link DGS-3000 series - Config Configuration

DGS-3000 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
145
DGS-3000-26TC:admin#show config modified
Command: show config modified
#-------------------------------------------------------------------------------
# DGS-3000-26TC Gigabit Ethernet Switch
# Configuration
#
# Firmware: Build 1.00.015
# Copyright(C) 2013 D-Link Corporation. All rights reserved.
#-------------------------------------------------------------------------------
# DEVICE
# BASIC
# ACCOUNT LIST
create account admin admin
admin
admin
CTRL+C ESC q Quit SPACE n Next Page ENTER Next Entry a All
15-2 config configuration
Description
This command is used to select a configuration file as the next boot up configuration or to apply a
specific configuration to the system. This command is required when multiple configuration files
are supported.
Format
config configuration <pathname 64> [boot_up | active]
Parameters
<pathname 64> - Specifies a configuration file on the device file system.
boot_up - Specifies it as a boot up file.
active - Specifies to apply the configuration.
Restrictions
Only Administrators can issue this command.
Example
To configure the Switch’s configuration file as boot up: