D-Link DGS-3000 series - Page 177

DGS-3000 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
173
13 0 0 0 0 0 0
14 0 0 0 0 0 0
15 0 0 0 0 0 0
16 0 0 0 0 0 0
17 0 0 0 0 0 0
18 0 0 0 0 0 0
19 0 0 0 0 0 0
20 0 0 0 0 0 0
21 0 0 0 0 0 0
22 0 0 0 0 0 0
23 0 0 0 0 0 0
24 0 0 0 0 0 0
25 0 0 0 0 0 0
26 0 0 0 0 0 0
DGS-3000-26TC:admin#show cfm pkt_cnt ccm
Command: show cfm pkt_cnt ccm
CCM RX counters:
XCON = Cross-connect CCMs
Error = Error CCMs
Normal = Normal CCMs
MEP Name VID Port Level Direction XCON Error Normal
----------- ---- ----- ------ ---------- ---------- ---------- ----------
DGS-3000-26TC:admin#
16-26 clear cfm pkt_cnt
Description
This command is used to clear the CFM packet’s RX/TX counters.
Format
clear cfm pkt_cnt {[ports <portlist> {[rx | tx]} | [rx | tx] | ccm]}
Parameters
ports - (Optional) The ports which require need the counters clearing. If not specified, all ports
will be cleared.
<portlist> - Enter the list of ports used for this configuration here.
rx - (Optional) Specifies to clear the RX counter.
tx - (Optional) Specifies to clear the TX counter. If not specified, both of them will be cleared.
rx - (Optional) Specifies to clear the RX counter.
tx - (Optional) Specifies to clear the TX counter. If not specified, both of them will be cleared.
ccm - (Optional) Specifies the CCM RX counters.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.