D-Link DGS-3000 series - Chapter 26 Energy Efficient Ethernet (EEE) Commands

DGS-3000 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
235
Chapter 26 Energy Efficient Ethernet
(EEE) Commands
config eee ports [<portlist> | all] state [enable | disable]
show eee ports {<portlist>}
26-1 config eee ports
Description
This command is used to enable or disable the EEE function on the specified port(s) on the Switch.
Note: The two functions, EEE and ERPS, are mutually exclusive.
Format
config eee ports [<portlist> | all] state [enable | disable]
Parameters
<portlist> - Enter a range of ports to be configured.
all - Specifies to configure all ports.
state - Specifies the EEE state. The default is disabled.
enable - Enable the EEE function for the specified port(s).
disable - Disable the EEE function for the specified port(s).
Restrictions
Only Administrators and Operators can issue this command.
Example
To enable the EEE state on ports 2-5:
DGS-3000-26TC:admin#config eee ports 2-5 state enable
Command: config eee ports 2-5 state enable
Success.
DGS-3000-26TC:admin#
26-2 show eee ports
Description
This command is used to display the EEE function state on the specified port(s).