D-Link DGS-3000 series - Page 245

DGS-3000 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
241
unblocked RPL port and start to send R-APS PDU with an RB flag after the link recovery is
confirmed within this period of time.
Revertive mode- When revertive is enabled, the traffic link is restored to the working transport link.
When revertive is disabled, the traffic link is allowed to use the RPL, after recovering from a failure.
When both the global state and the specified ring ERPS state are enabled, the specified ring will
be activated. EEE, STP and LBD should be disabled on the ring ports before the specified ring is
activated.
The ring cannot be enabled before the R-APS VLAN is created, and ring ports, RPL port, RPL
owner, are configured. Note that these parameters cannot be changed when the ring is activated.
In order to guarantee correct operation, the following integrity will be checked when the ring is
enabled and the global ERPS state is enabled.
1. R-APS VLAN is created.
2. The Ring port is the tagged member port of the R-APS VLAN.
3. The RPL port is specified if RPL owner is enabled.
Format
config erps raps_vlan <vlanid> [state [enable | disable] | ring_mel <value 0-7> | ring_port
[west <port> | east <port> ] | rpl_port [west | east | none] | rpl_owner [enable | disable] |
protected_vlan [add | delete] vlanid <vidlist> | revertive [enable | disable] | timer
{holdoff_time <millisecond 0 - 10000> | guard_time <millisecond 10 - 2000> | wtr_time <min
5 - 12>}]
Parameters
<vlanid> - Enter the R-APS VLAN ID used.
state - Specifies to enable or disable the specified ring.
enable - Enable the state of the specified ring.
disable - Disable the state of the specified ring. The default value is disabled.
ring_mel - Specifies the ring MEL of the R-APS function. The default ring MEL is 1.
<value 0-7> - Enter the ring MEL value here. This value should be between 0 and 7.
ring_port - Specifies the ring port used.
west - Specifies the port as the west ring port.
<port> - Enter the port number here.
east - Specifies the port as the east ring port.
<port> - Enter the port number here.
rpl_port - Specifies the RPL port used.
west - Specifies the west ring port as the RPL port.
east - Specifies the east ring port as the RPL port.
none - No RPL port on this node. By default, the node has no RPL port.
rpl_owner - Specifies to enable or disable the RPL owner node.
enable - Specifies the device as an RPL owner node.
disable - This node is not an RPL owner. By default, the RPS owner is disabled.
protected_vlan - Specifies to add or delete the protected VLAN group.
add - Adds VLANs to the protected VLAN group.
delete - Deletes VLANs from the protected VLAN group.
vlanid - Specifies the VLAN ID to be removed or added.
<vidlist> - Enter the VLAN ID list here.