DGS-3000 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
242
revertive - Specifies the state of the R-APS revertive option.
enable - Specifies that the R-APS revertive option will be enabled.
disable - Specifies that the R-APS revertive option will be disabled.
timer - Specifies the R-APS timer used.
holdoff_time - (Optional) Specifies the holdoff time of the R-APS function. The default holdoff
time is 0 milliseconds.
<millisecond 0-10000> - Enter the hold off time value here. This value must be in the
range of 0 to 10000 millseconds.
guard_time - (Optional) Specifies the guard time of the R-APS function. The default guard
time is 500 milliseconds.
<millisecond 10-2000> - Enter the guard time value here. This value must be in the range
of 0 to 2000 millseconds.
wtr_time - (Optional) Specifies the WTR time of the R-APS function.
<min 5-12> - Enter the WTR time range value here. The range is from 5 to 12 minutes.
The default WTR time is 5 minutes.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure the MEL of the ERPS ring for a specific R-APS VLAN:
DGS-3000-26TC:admin#config erps raps_vlan 4094 ring_mel 2
Command: config erps raps_vlan 4094 ring_mel 2
Success.
To configure the ports of the ERPS ring for a specific R-APS VLAN:
DGS-3000-26TC:admin#config erps raps_vlan 4094 ring_port west 5
Command: config erps raps_vlan 4094 ring_port west 5
Success.
To configure the RPL owner for a specific R-APS VLAN:
DGS-3000-26TC:admin#config erps raps_vlan 4094 rpl_owner enable
Command: config erps raps_vlan 4094 rpl_owner enable
Success.
To configure the protected VLAN for a specific R-APS VLAN:
To Next Page
Loading...
