D-Link DGS-3000 series - Page 266

DGS-3000 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
262
31-2 md
Description
This command is used to create a directory.
Format
md {<drive_id>} <pathname>
Parameters
<drive_id> - (Optional) Enter the drive ID used, for example, C:.
<pathname> - Specifies the directory. The path name can be specified either as a full path name
or partial name. For partial path name, it indicates the file is in the current directory. The drive
ID also included in this parameter, for example, c:/config/bootup.cfg.
Restrictions
Only Administrators and Operators can issue this command.
Example
To make a directory:
DGS-3000-26TC:admin#md c:/abc
Command: md c:/abc
Success.
DGS-3000-26TC:admin#
31-3 rd
Description
This command is used to remove a directory. If there are files still existing in the directory, this
command will fail and return error message.
Format
rd {<drive_id>} <pathname>
Parameters
<drive_id> - (Optional) Enter the drive ID used, for example, C:.
<pathname> - Specifies the directory to be removed. The path name can be specified either as a
full path name or partial name. For partial path name, it indicates the file is in the current
directory.
Restrictions
Only Administrators and Operators can issue this command.