D-Link DGS-3000 series - Page 281

DGS-3000 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
277
clear igmp_snooping statistics counter
show igmp_snooping host {[vlan <vlan_name 32> | vlanid <vlanid_list> | ports <portlist> | group
<ipaddr>]}
33-1 config igmp_snooping
Description
This command is used to configure IGMP snooping on the Switch.
Format
config igmp_snooping [vlan_name <vlan_name 32> | vlanid <vlanid_list> | all ] {state
[enable | disable] | fast_leave [enable | disable] | report_suppression [enable | disable] |
proxy_reporting {state [enable | disable] | source_ip <ipaddr>}(1)}(1)
Parameters
vlan_name - Specifies the name of the VLAN for which IGMP snooping is to be configured.
<vlan_name 32> - Enter the VLAN name here. The VLAN name can be up to 32 characters
long.
vlanid - Specifies the VLAN ID for which IGMP snooping is to be configured.
<vlanid_list> - Enter the VLAN ID here.
all - Specifies to use all configured VLANs.
state - (Optional) Specifies to enable or disable IGMP snooping for the chosen VLAN.
enable - Specifies to enable IGMP snooping for the chosen VLAN.
disable - Specifies to disable IGMP snooping for the chosen VLAN.
fast_leave - Specifies to enable or disable the IGMP snooping fast leave function.
enable - Specifies to enable the IGMP snooping fast leave function. If enabled, the
membership is immediately removed when the system receives the IGMP leave message.
disable - Specifies to disable the IGMP snooping fast leave function.
report_suppression - Specifies whether to use IGMP report suppression to forward only one
IGMP report per multicast router query to multicast devices.
enable - Specifies to use IGMP report suppression to forward only one IGMP report per
multicast router query to multicast devices.
disable - Disables IGMP report suppression to forward only one IGMP report per multicast
router query to multicast devices.
proxy reporting - Specifies IGMP proxy reporting. If enabled, multiple IGMP reports or leave for
a specific (S, G) will be integrated into one report only before sending to the router port.
state - Specifies to enable or disable the proxy reporting.
enable - Specifies to enable the proxy reporting.
disable - Specifies to disable the proxy reporting.
source_ip - Specifies the source IP of proxy reporting integrated report. Default value is zero
IP.
<ipaddr> - Enter the IP address.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure IGMP snooping: