D-Link DGS-3000 series - Config Vlan; Config Vlan Vlanid

DGS-3000 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
25
DGS-3000-26TC:admin#delete vlan vlanid 10-30
Command: delete vlan vlanid 10-30
Success.
DGS-3000-26TC:admin#
3-5 config vlan
Description
This command is used to configure a VLAN based on the name.
Format
config vlan <vlan_name 32> {[add [tagged | untagged | forbidden] | delete] <portlist> |
advertisement [enable | disable]}(1)
Parameters
<vlan_name 32> - Enter the VLAN name you want to add ports to. This name can be up to 32
characters long.
add - (Optional) Specifies to add tagged, untagged or forbidden ports to the VLAN.
tagged - Specifies the additional ports as tagged.
untagged - Specifies the additional ports as untagged.
forbidden - Specifies the additional ports as forbidden.
delete - (Optional) Specifies to delete ports from the VLAN.
<portlist> - (Optional) Enter the list of ports used for the configuration here.
advertisement - (Optional) Specifies the GVRP state of this VLAN.
enable - Specifies to enable advertisement for this VLAN.
disable - Specifies to disable advertisement for this VLAN.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To add 4 through 8 as tagged ports to the VLAN v2:
DGS-3000-26TC:admin#config vlan v2 add tagged 4-8
Command: config vlan v2 add tagged 4-8
Success.
DGS-3000-26TC:admin#
3-6 config vlan vlanid
Description
This command allows you to configure multiple VLANs at one time. But conflicts will be generated
if you configure the name of multiple VLANs at one time.