D-Link DGS-3000 series - Chapter 37 Japanese Web-Based Access Control (JWAC) Command List

DGS-3000 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
332
Chapter 37 Japanese Web-Based
Access Control (JWAC)
Command List
enable jwac
disable jwac
config jwac [quarantine_server_url <string 128> | clear_quarantine_server_url]
show jwac
enable jwac redirect
disable jwac redirect
config jwac redirect {destination [quarantine_server | jwac_login_page] | delay_time <sec 0-
10>}(1)
enable jwac forcible_logout
disable jwac forcible_logout
enable jwac udp_filtering
disable jwac udp_filtering
enable jwac quarantine_server_monitor
disable jwac quarantine_server_monitor
config jwac quarantine_server_error_timeout <sec 5-300>
config jwac virtual_ip <ipaddr> {url [<string 128> | clear]}
config jwac update_server [add | delete] ipaddress <network_address> {[tcp_port <port_number
1-65535> | udp_port <port_number 1-65535>]}
config jwac switch_http_port <tcp_port_number 1-65535> {[http | https]}
config jwac ports [<portlist> | all] {state [enable | disable] | max_authenticating_host <value 0-50>
| aging_time [infinite | <min 1-1440>] | idle_time [infinite | <min 1-1440>] | block_time [<sec 0-
300>] | auth_mode [host_based | port_based]}(1)
show jwac ports {<portlist>}
config jwac radius_protocol [local | eap_md5 | pap | chap | ms_chap | ms_chapv2]
create jwac user <username 15> {vlan <vlanid 1-4094>}
config jwac user <username 15> {vlan <vlanid 1-4094>}
delete jwac [user <username 15> | all_users]
show jwac user
clear jwac auth_state [ports [all | <portlist>] {authenticated | authenticating | blocked} | mac_addr
<macaddr>]
show jwac auth_state ports {<portlist>}
config jwac authorization attributes {radius [enable | disable] | local [enable | disable]}(1)
show jwac update_server
config jwac authentication_page element [japanese | english] [default | page_title <desc 128> |
login_window_title <desc 32> | user_name_title <desc 16> | password_title <desc 16> |
logout_window_title <desc 32> | notification_line <value 1-5> <desc 128>]
config jwac authenticate_page [japanese | english]
show jwac authenticate_page
37-1 enable jwac
Description
This command is used to enable the Japanese Web-based access control (JWAC) function.
Using the JWAC function, PC users need to pass two stages of authentication. The first stage is to
do the authentication with the quarantine server and the second stage is the authentication with
the Switch.