D-Link DGS-3000 series - Page 369

DGS-3000 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
365
DGS-3000-26TC:admin#show link_aggregation
Command: show link_aggregation
Link Aggregation Algorithm = MAC-Source-Dest
Group ID : 1
Type : LACP
Master Port : 5
Member Port : 5-7
Active Port :
Status : Enabled
Flooding Port :
Total Entries : 1
DGS-3000-26TC:admin#
Link aggregation group disabled:
DGS-3000-26TC:admin#show link_aggregation
Command: show link_aggregation
Link Aggregation Algorithm = MAC-Source-Dest
Group ID : 1
Type : LACP
Master Port : 5
Member Port : 5-7
Active Port :
Status : Disabled
Flooding Port : 7
Total Entries : 1
DGS-3000-26TC:admin#
40-6 config lacp_port
Description
This command is used to configure per-port LACP mode.
Format
config lacp_port <portlist> mode [active | passive]
Parameters
lacp_port - Specifies a range of ports to be configured.
<portlist> - Enter the list of port used for the configuration here.
mode - Specifies the LACP mode used.
active - Specifies to set the LACP mode as active.