D-Link DGS-3000 series - Debug Stp Show Counter

DGS-3000 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
452
DGS-3000-26TC:admin#debug stp show flag
Command: debug stp show flag
Global State: Disabled
Port Index Event Flag BPDU Flag State Machine Flag
----------------------------------------------------------
1 Disabled Disabled Disabled
2 Disabled Disabled Disabled
3 Disabled Disabled Disabled
4 Disabled Disabled Disabled
5 Disabled Disabled Disabled
6 Disabled Disabled Disabled
7 Disabled Disabled Disabled
8 Disabled Disabled Disabled
9 Disabled Disabled Disabled
10 Disabled Disabled Disabled
11 Disabled Disabled Disabled
12 Disabled Disabled Disabled
13 Disabled Disabled Disabled
14 Disabled Disabled Disabled
15 Disabled Disabled Disabled
16 Disabled Disabled Disabled
17 Disabled Disabled Disabled
18 Disabled Disabled Disabled
19 Disabled Disabled Disabled
20 Disabled Disabled Disabled
21 Disabled Disabled Disabled
22 Disabled Disabled Disabled
23 Disabled Disabled Disabled
24 Disabled Disabled Disabled
25 Disabled Disabled Disabled
26 Disabled Disabled Disabled
DGS-3000-26TC:admin#
48-4 debug stp show counter
Description
This command is used to display the STP counters.
Format
debug stp show counter {ports [<portlist> | all]}
Parameters
ports - (Optional) Specifies the STP ports for display.
<portlist> - Enter the list of port used for this configuration here.
all - Display all port’s counters.
If no parameter is specified, display the global counters.