D-Link DGS-3000 series - Page 51

DGS-3000 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
47
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure the parameters that control the operation of the authenticator associated with a port:
DGS-3000-26TC:admin#config 802.1x auth_parameter ports 1-20 direction both
Command: config 802.1x auth_parameter ports 1-20 direction both
Success.
DGS-3000-26TC:admin#
4-14 config 802.1x auth_mode
Description
This command is used to configure 802.1X authentication mode.
Format
config 802.1x auth_mode [port_based | mac_based]
Parameters
port_based - Specifies the authentication as the port-based mode.
mac_based - Specifies the authentication as the MAC-based mode.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure the authentication mode:
DGS-3000-26TC:admin#config 802.1x auth_mode port_based
Command: config 802.1x auth_mode port_based
Success.
DGS-3000-26TC:admin#
4-15 config 802.1x init
Description
This command is used to initialize the authentication state machine of some or all ports.