D-Link DGS-3000 series - Page 52

DGS-3000 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
48
Format
config 802.1x init [port_based ports [<portlist> | all] | mac_based ports [<portlist> | all]
{mac_address <macaddr>}]
Parameters
port_based ports- Specifies the authentication as the port-based mode.
<portlist> - Enter the list of ports used for the configuration here.
all - Specifies that all ports will be used.
mac_based ports - Specifies the authentication as the MAC-based mode.
<portlist> - Enter the list of ports used for the configuration here.
all - Specifies that all ports will be used.
mac_address - (Optional) Specifies the MAC address of client.
<macaddr> - Enter the MAC address used here.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To initialize the authentication state machine of some or all:
DGS-3000-26TC:admin#config 802.1x init port_based ports all
Command: config 802.1x init port_based ports all
Success.
DGS-3000-26TC:admin#
4-16 config 802.1x reauth
Description
This command is used to re-authenticate the device connected to the port. During the re-
authentication period, the port status remains authorized until failed re-authentication.
Format
config 802.1x reauth [port_based ports [<portlist> | all] | mac_based ports [<portlist> | all]
{mac_address <macaddr>}]
Parameters
port_based ports - Specifies the authentication as the port-based mode.
<portlist> - Enter the list of ports used for the configuration here.
all - Specifies that all ports will be used.
mac_based ports - Specifies the authentication as the MAC-based mode.
<portlist> - Enter the list of ports used for the configuration here.
all - Specifies that all ports will be used.
mac_address - (Optional) Specifies the MAC address of client.
<macaddr> - Enter the MAC address used here.