D-Link DGS-3000 series - Page 557

DGS-3000 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
553
DGS-3000-26TC:admin#show bandwidth_control 1-10
Command: show bandwidth_control 1-10
Bandwidth Control Table
Port RX Rate TX Rate Effective RX Effective TX
(Kbit/sec) (Kbit/sec) (Kbit/sec) (Kbit/sec)
----- ---------- ---------- ---------------- ----------------
1 No Limit 64 No Limit 64
2 No Limit 64 No Limit 64
3 No Limit 64 No Limit 64
4 No Limit 64 No Limit 64
5 No Limit 64 No Limit 64
6 No Limit 64 No Limit 64
7 No Limit 64 No Limit 64
8 No Limit 64 No Limit 64
9 No Limit 64 No Limit 64
10 No Limit 64 No Limit 64
DGS-3000-26TC:admin#
62-3 config per_queue bandwidth_control
Description
This command is used to configure per port CoS bandwidth control.
Format
config per_queue bandwidth_control {ports [<portlist> | all]} <cos_id_list 0-7> {{min_rate
[no_limit | <value 64-10240000>]} max_rate [no_limit | <value 64-10240000>]}
Parameters
ports - (Optional) Specifies a range of ports to be configured.
<portlist> - Enter the list of port used for this configuration here.
all - For set all ports in the system, you may use “all” parameter. If no parameter is specified,
system will set all ports.
<cos_id_list 0-7> - Specifies a list of priority queues. The priority queue number is ranged from 0
to 7.
min_rate - (Optional) Specifies that one of the parameters below (no_limit or <value m-n) will be
applied to the mini-rate at which the above specified class will be allowed to receive packets.
no_limit - Specifies that there will be no limit on the rate of packets received by the above
specified class.
<value 64-10240000> - Specifies the packet limit, in Kbps, that the above ports will be
allowed to receive. If the specified rate is not multiple of minimum granularity, the rate will
be adjusted.
max_rate - (Optional) Specifies that one of the parameters below (no_limit or <value m-n >) will
be applied to the maximum rate at which the above specified class will be allowed to transmit
packets.
no_limit - Specifies that there will be no limit on the rate of packets received by the above
specified class.
<value 64-10240000> - Specifies the packet limit, in Kbps, that the above ports will be