D-Link DGS-3000 series - Page 563

DGS-3000 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
559
62-9 config 802.1p user_priority
Description
This command is used to map the 802.1p user priority of an incoming packet to one of the eight
hardware queues available on the Switch.
Format
config 802.1p user_priority <priority 0-7> <class_id 0-7>
Parameters
<priority 0-7> - The 802.1p user priority you want to associate with the <class_id> (the number
of the hardware queue) with.
<class_id 0-7> - The number of the Switch’s hardware priority queue. The switch has 8 hardware
priority queues available. They are numbered between 0 (the lowest priority) and 7 (the
highest priority).
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure the 802.1p user priority:
DGS-3000-26TC:admin#config 802.1p user_priority 1 3
Command: config 802.1p user_priority 1 3
Success.
DGS-3000-26TC:admin#
62-10 show 802.1p user_priority
Description
This command is used to display 802.1p user priority for ports.
Format
show 802.1p user_priority
Parameters
None.
Restrictions
None.