D-Link DGS-3000 series - Page 620

DGS-3000 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
616
Format
config snmp system_location {<sw_location>}
Parameters
<sw_location> - (Optional) Enter the SNMP system location string here. This string can be up to
255 characters long.
Restrictions
Only Administrators and Operators can issue this command.
Example
To configure the Switch location for “HQ 5F”:
DGS-3000-26TC:admin#config snmp system_location HQ 5F
Command: config snmp system_location HQ 5F
Success.
DGS-3000-26TC:admin#
69-23 config snmp system_contact
Description
This command is used to enter the name of a contact person who is responsible for the Switch.
Format
config snmp system_contact {<sw_contact>}
Parameters
<sw_contact> - (Optional) Enter the SNMP system contact string here. This name can be up to
255 characters long.
Restrictions
Only Administrators and Operators can issue this command.
Example
To configure the Switch contact to “MIS Department II”:
DGS-3000-26TC:admin#config snmp system_contact "MIS Department II"
Command: config snmp system_contact "MIS Department II"
Success.
DGS-3000-26TC:admin#