D-Link DGS-3000 series - Page 624

DGS-3000 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
620
Parameters
None.
Restrictions
Only Administrators and Operators can issue this command.
Example
To disable the sending of linkchange traps:
DGS-3000-26TC:admin#disable snmp linkchange_traps
Command: disable snmp linkchange_traps
Success.
DGS-3000-26TC:admin#
69-30 config snmp linkchange_traps ports
Description
This command is used to configure the sending of linkchange traps and per port control for
sending of change trap.
Format
config snmp linkchange_traps ports [all | <portlist>] [enable | disable]
Parameters
all - Specifies that all ports will be used.
<portlist> - Enter the range of ports used.
enable - Enables the sending of the link change trap for this port.
disable - Disables the sending of the link change trap for this port.
Restrictions
Only Administrators can issue this command.
Example
To configure the sending of linkchange traps:
DGS-3000-26TC:admin#config snmp linkchange_traps ports 1-4 enable
Command: config snmp linkchange_traps ports 1-4 enable
Success.
DGS-3000-26TC:admin#