D-Link DGS-3000 series - Page 9

DGS-3000 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
5
DGS-3000-26TC:admin#show
Command: show
Next possible completions:
802.1p 802.1x aaa access_profile
account accounting acct_client address_binding
arp_spoofing_prevention arpentry attack_log
auth_client auth_diagnostics auth_session_statistics
auth_statistics authen authen_enable authen_login
authen_policy authentication authorization autoconfig
bandwidth_control boot_file bpdu_protection cfm
command command_history config control_pkt
cpu cpu_filter current_config ddm
device_status dhcp_local_relay dhcp_relay dos_prevention
dot1v_protocol_group dscp duld
environment erps error ethernet_oam
external_alarm fdb filter flow_meter
gratuitous_arp greeting_message gvrp host_name
igmp igmp_snooping ipif
ipif_ipv6_link_local_auto iproute ipv6
ipv6route jumbo_frame jwac l2protocol_tunnel
lacp_port led limited_multicast_addr
link_aggregation lldp lldp_med log
log_save_timing log_software_module loopdetect
mac_based_access_control mac_based_access_control_local
mac_based_vlan mac_notification max_mcast_group
mcast_filter_profile mirror mld_snooping
multicast multicast_fdb name_server nlb
packet password_recovery per_queue port
port_security port_security_entry port_vlan
ports power_saving pppoe private_vlan
pvid qinq radius rmon
router_ports safeguard_engine scheduling
scheduling_mechanism serial_port session
sim smtp snmp sntp
ssh ssl storage_media_info
stp switch syslog system_severity
tech_support terminal tftp time
time_range traffic traffic_segmentation
trap trusted_host utilization vlan
vlan_translation vlan_trunk voice_vlan
DGS-3000-26TC:admin#
In the above example, all of the possible next parameters for the show command are displayed. At
the next command prompt, the up arrow was used to re-enter the show command, followed by the
account parameter. The CLI then displays the user accounts configured on the Switch.