DGS-3100 Series Gigabit Stackable Managed Switch User Manual
4
Using the Web-Based User Interface
This section contains information on starting the D-Link Embedded Web Interface. To access the D-Link user interface:
1. Open an Internet browser. Ensure that pop-up blockers are disabled. If pop-up blockers are enabled, edit, add,
and device information messages may not open.
2. Enter the device IP address in the address bar and press Enter.
The user interface provides access to various switch configuration and management windows, allows you to view
performance statistics, and permits you to graphically monitor the system status.
The screen captures in this Guide represent the
DGS-3100-48 48 port device. The Web pages in the 24 port and the DGS-3100-24TG devices may vary slightly.
To Next Page
Loading...
