D-Link DGS-3120-24PC - Page 243

xStack
®
DGS-3120 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
239
22-19 debug dhcpv6_relay hop_count state (EI Mode Only)
Description
This command is used to enable or disable debug information flag about the hop count.
Format
debug dhcpv6_relay hop_count state [enable | disable]
Parameters
enable - Specify to enable the hop count state.
disable - Specify to disable the hop count state.
Restrictions
Only Administrator-level users can issue this command.
Example
To enable debug information flag about the hop count:
DGS-3120-24TC:admin#debug dhcpv6_relay hop_count state enable
Command: debug dhcpv6_relay hop_count state enable
Success.
DGS-3120-24TC:admin#