D-Link DGS-3120-24PC - Page 436

xStack
®
DGS-3120 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
432
DGS-3120-24TC:admin# config lldp ports all dot1_tlv_vlan_name vlanid 1-3
enable
Command: config lldp ports all dot1_tlv_vlan_name vlanid 1-3 enable
Success.
DGS-3120-24TC:admin#
To configure exclude the protocol identity TLV from the outbound LLDP advertisements for all
ports:
DGS-3120-24TC:admin# config lldp ports all dot1_tlv_protocol_identity all
enable
Command: config lldp ports all dot1_tlv_protocol_identity all enable
Success.
DGS-3120-24TC:admin#
To configure exclude the MAC/PHY configuration/status TLV from the outbound LLDP
advertisements for all ports:
DGS-3120-24TC:admin# config lldp ports all dot3_tlvs
mac_phy_configuration_status enable
Command: config lldp ports all dot3_tlvs mac_phy_configuration_status enable
Success.
DGS-3120-24TC:admin#
43-6 config lldp forward_ message
Description
This command is used to configure forwarding of LLDP PDU packet when LLDP is disabled.
Format
config lldp forward_message [enable | disable]
Parameters
None.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure LLDP to forward LLDP PDUs: