xStack
®
DGS-3120 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
692
76-23 config snmp system_location
Description
This command is used to enter a description of the location of the Switch.
Format
config snmp system_location {<sw_location>}
Parameters
system_location - A maximum of 128 characters is allowed. And NULL string is accepted
<sw_location> - (Optional) Enter the system location string here.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To configure the Switch location for “HQ 5F”:
DGS-3120-24TC:admin# config snmp system_location HQ 5F
Command: config snmp system_location HQ 5F
Success.
76-24 config snmp system_contact
Description
This command is used to enter the name of a contact person who is responsible for the Switch.
Format
config snmp system_contact {<sw_contact>}
Parameters
system_contact - A maximum of 128 characters is allowed. And NULL string is accepted.
<sw_contact> - (Optional) Enter the system contact string here.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To configure the Switch contact to “MIS Department II”:
To Next Page
Loading...
