D-Link DGS-3120-24PC - Page 745

xStack
®
DGS-3120 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
741
apply the setting to the system. If increment is specified, the existing configuration will not
be cleared before applying to the new configuration. If it is not specified, the existing
configuration will be cleared before applying to the new configuration.
dest_file - (Optional) Used to identify the parameter “path_filename”.
<pathname>- The pathname specifies an absolute pathname on the device file system. If
pathname is not specified, it refers to the boot_up configuration file.
Restrictions
Only Administrator-level users can issue this command.
Example
To download firmware from TFTP:
DGS-3120-24TC:admin# download firmware_fromTFTP 10.54.71.1 src_file px.had
Command: download firmware_fromTFTP 10.54.71.1 src_file px.had
Connecting to server................... Done.
Download firmware...................... Done. Do not power off!
Please wait, programming flash......... Done.
DGS-3120-24TC:admin#
To download configuration from TFTP:
DGS-3120-24TC:admin# download cfg_fromTFTP 10.54.71.1 src_file cfg01.txt
Command: download cfg_fromTFTP 10.54.71.1 src_file cfg01.txt
Connecting to server.................…. Done.
Download configuration................. Done.
DGS-3120-24TC:admin#
83-2 upload
Description
This command is used to upload firmware and configuration from device to TFTP server.
Format
upload [cfg_toTFTP [<ipaddr> | <ipv6addr>] dest_file <path_filename 64> {unit <unit_id>}
{src_file <pathname>} {[include | exclude | begin] <filter_string 80> {<filter_string 80>
{<filter_string 80>}} {[include | exclude | begin] <filter_string 80> {<filter_string 80>
{<filter_string 80>}} {[include | exclude | begin ] <filter_string 80> {<filter_string 80>
{<filter_string 80>}}}}} | log_toTFTP [<ipaddr> | <ipv6addr>] dest_file <path_filename 64> |
attack_log_toTFTP [<ipaddr> | <ipv6addr>] dest_file <path_filename 64> {unit <unit_id>} |
firmware_toTFTP [<ipaddr> | <ipv6addr>] dest_file <path_filename 64> {unit <unit_id>}
{src_file <pathname>}]