xStack
®
DGS-3120 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
834
authenticated successful.
(Username: <string>, IP: <ipaddr
| ipv6address>, MAC:
<macaddr>, Port: <[unitID:]
When a client host fails to
JWAC unauthenticated user
(User Name: <string>, IP:
<ipaddr | ipv6address>, MAC:
<macaddr>, Port:
This log will be triggered
when the number of
authorized users reaches
the maximum user limit on
JWAC enters stop learning state.
This log will be triggered
when the number of
authorized users is below
the maximum user limit on
whole device in 5 minutes
authenticated successful.
(Username: <string>, IP: <ipaddr
| ipv6address>, MAC:
<macaddr>, Port: <[unitID:]
When a client host fails to
WAC unauthenticated user (User
Name: <string>, IP: <ipaddr |
ipv6address>, MAC: <macaddr>,
Port: <[unitID:]portNum>)
number on whole device
reaches the max user
WAC enters stop learning state.
number on whole device
is below the max user limit
in a time interval(interval
WAC recovers from stop learning
address encountered and
discarded by IP-MAC port
address and discarded by IMPB
(IP: <ipaddr>, MAC: <macaddr>,
Dynamic IMPB entry conflicts
with static ARP(IP: <ipaddr>,
MAC: <macaddr>, Port
Dynamic IMPB entry conflicts
with static FDB(IP: <ipaddr>,
MAC: <macaddr>, Port
conflicts with static IMPB
Dynamic IMPB entry conflicts
with static IMPB(IP: <ipaddr>,
MAC: <macaddr>, Port
Creating IMPB entry failed
due to no ACL rule
available
Creating IMPB entry failed due to
no ACL rule being
available(IP:<ipaddr>, MAC:
<macaddr>, Port
IP Address change activity
[Unit <unitID>,] Management IP
address was changed by
console(Username:
<username>,IP:<ipaddr>)
"IP: <ipaddr>"
are XOR shown
in log string,
which means if
user login by
console, there
will no IP
information for
[Unit <unitID>,] Password was
changed by console (Username:
<username>,IP:<ipaddr> )
"IP: <ipaddr>"
are XOR shown