EasyManua.ls Logo

D-Link DGS-3120-24PC - Page 843

D-Link DGS-3120-24PC
852 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
xStack
®
DGS-3120 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
839
uccess
Control host is successfully logged in.
Binding
1. swMacBasedAuthInfoMacIndex
2. swMacBasedAuthInfoPortIndex
3. swMacBasedAuthVID
swMacBasedAccessControlLoggedFa
il
The trap is sent when a MAC-based Access
Control host login fails
Binding
1. swMacBasedAuthInfoMacIndex
2. swMacBasedAuthInfoPortIndex
3. swMacBasedAuthVID
1.3.6.1.4.1.171.12.35.11.1.0.2
swMacBasedAccessControlAgesOut
The trap is sent when a MAC-based Access
Control host ages out.
Binding
1. swMacBasedAuthInfoMacIndex
2. swMacBasedAuthInfoPortIndex
3. swMacBasedAuthVID
1.3.6.1.4.1.171.12.35.11.1.0.3
swFilterDetectedTrap
Send trap when illegal DHCP server is
detected. The same illegal DHCP server IP
address detected is just sent once to the
trap receivers within the log ceasing
unauthorized duration.
Binding
1. swFilterDetectedIP
2. swFilterDetectedport
1.3.6.1.4.1.171.12.37.100.0.1
swPortLoopOccurred
The trap is sent when a Port loop occurs.
Binding
1. swLoopDetectPortIndex
1.3.6.1.4.1.171.12.41.10.0.1
swPortLoopRestart
The trap is sent when a Port loop restarts
after the interval time.
Binding
1. swLoopDetectPortIndex
1.3.6.1.4.1.171.12.41.10.0.2
swVlanLoopOccurred
The trap is sent when a Port with a VID loop
occurs.
Binding
1. swLoopDetectPortIndex
2. swVlanLoopDetectVID
1.3.6.1.4.1.171.12.41.10.0.3
swVlanLoopRestart
The trap is sent when a Port with a VID loop
restarts after the interval time.
Binding
1. swLoopDetectPortIndex
2. swVlanLoopDetectVID
1.3.6.1.4.1.171.12.41.10.0.4
swBpduProtectionUnderAttackingTra
p
When the BPDU Protection trap is enabled,
if the specific port changes from a normal
state to an under attack state, a trap will be
sent out.
Binding
1. swBpduProtectionPortIndex
2. swBpduProtectionPortMode
1.3.6.1.4.1.171.12.76.4.0.1
swBpduProtectionRecoveryTrap
When the BPDU Protection trap is enabled,
if the specific port changes from an under
attack state to a normal state, a trap will be
sent out.
1. swBpduProtectionPortIndex
2. swBpduProtectionRecoveryMethod
1.3.6.1.4.1.171.12.76.4.0.2
swERPSSFDetectedTrap
When a signal failure occurs, a trap will be
generated.
Binding
1. swERPSNodeId
1.3.6.1.4.1.171.12.78.4.0.1
swERPSSFClearedTrap
When the signal failure clears, a trap will be
generated.
Binding
1. swERPSNodeId
1.3.6.1.4.1.171.12.78.4.0.2
swERPSRPLOwnerConflictTrap
When a conflict occurs, a trap will be
generated.
Binding
1. swERPSNodeId
1.3.6.1.4.1.171.12.78.4.0.3
dot1agCfmFaultAlarm
A MEP has a persistent defect condition. A
notification
(fault alarm) is sent to the management
1.3.111.2.802.1.1.8.0.1

Table of Contents

Other manuals for D-Link DGS-3120-24PC

Related product manuals