D-Link DGS-3120-24TC - Page 117

xStack® DGS-3120 Series Managed Switch Web UI Reference Guide
109
Figure 4–68 IGMP Snooping Multicast VLAN Settings – Edit window
The fields that can be configured are described below:
Parameter Description
VLAN Name
This option will display the VLAN name of the VLAN configured.
State
Use the drop-down menu to enable or disable the state.
Replace Source IP
With the IGMP snooping function, the IGMP report packet sent by the host will be
forwarded to the source port. Before forwarding of the packet, the source IP
address in the join packet needs to be replaced by this IP address. If none is
specified, the source IP address will not be replaced.
Remap Priority 0-7 – The remap priority value (0 to 7) to be associated with the data traffic to be
forwarded on the multicast VLAN.
None – If None is specified, the packet’s original priority is used. The default setting
is None.
Replace Priority
Specify that the packet’s priority will be changed by the switch, based on the remap
priority. This flag will only take effect when the remap priority is set.
Untagged Member
Ports
Specify the untagged member port of the multicast VLAN. Click the Select All
button to select all the ports or click the
Clear All
button to unselect all the ports.
Tagged Member Ports Specify the tagged member port of the multicast VLAN. Click the Select All button
to select all the ports or click the Clear All button to unselect all the ports.
Untagged Source Ports
Specify the source port or range of source ports as untagged members of the
multicast VLAN. The PVID of the untagged source port is automatically changed to
the multicast VLAN. Source ports must be either tagged or untagged for any single
multicast VLAN, i.e. both types cannot be members of the same multicast VLAN.
Click the Select All button to select all the ports or click the Clear All button to
unselect all the ports.
Tagged Source Ports
Specify the source port or range of source ports as tagged members of the
multicast VLAN. Click the Select All button to select all the ports or click the Clear
All button to unselect all the ports.
Click the Select All button to select all the ports for configuration.
Click the Clear All button to unselect all the ports for configuration.
Click the Apply button to accept the changes made.
Click the <<Back button to discard the changes made and return to the previous page.
After clicking the
Profile List link, the following page will appear: