xStack® DGS-3120 Series Managed Switch Web UI Reference Guide
301
Figure 11–27 Trace Route window (EI Mode Only)
The fields that can be configured are described below:
Parameter Description
IPv4 Address / IPv6
IP address of the destination station.
TTL
The time to live value of the trace route request. This is the maximum number of
routers that a trace route packet can pass. The trace route option will cross while
seeking the network path between two devices.
The range for the TTL is 1 to 60 hops.
The port number. The value range is from 30000 to 64900.
Timeout
Defines the timeout period while waiting for a response from the remote device. A
value of 1 to 65535 seconds can be specified. The default is 5 seconds.
The number of probing. The range is from 1 to 9. If unspecified, the default value is 1.
Click the Start button to initiate the Trace Route.
After clicking the Start button, the following page will appear:
Figure 11–28 Trace Route Result window
Click the Stop button to halt the Trace Route.
Click the Resume button to resume the Trace Route.
To Next Page
Loading...
