D-Link DGS-3120-24TC - Page 40

xStack® DGS-3120 Series Managed Switch Web UI Reference Guide
32
Click the IPv4 Edit button to see the following window.
Figure 3–11 IPv4 Interface Settings – Edit window
The fields that can be configured are described below:
Parameter Description
Get IP From
Use the drop-down menu to specify the method that this Interface uses to acquire an
IP address.
Interface Name
Enter the name of the IP interface being configured.
IPv4 Address
Enter the IPv4 address used.
Subnet Mask
Enter the IPv4 subnet mask used.
VLAN Name
Enter the VLAN Name used.
IPv4 State
Use the drop-down menu to enable or disable IPv4 State.
Interface Admin State
Use the drop-down menu to enable or disable the Interface Admin State.
Click the Apply button to accept the changes made.
Click the <<Back button to discard the changes made and return to the previous page.
Click the IPv6 Edit button to see the following window.
Figure 3–12 IPv6 Interface Settings window (EI Mode Only)
The fields that can be configured are described below:
Parameter Description
Interface Name
Here the IPv6 interface name is displayed
IPv6 State
Here the user can select to enable or disable IPv6 State.
Interface Admin State
Here the user can select to enable or disable the Interface Admin State.
IPv6 Network Address
Here the user can enter the neighbor’s global or local link address.