D-Link DGS-3120-48PC - Page 124

xStack
®
DGS-3120 Series Managed Switch CLI Reference Guide
120
DGS-3120-24TC:admin#show egress_flow_meter
Command: show egress_flow_meter
Flow Meter Information
------------------------------------------------------------------------------
Profile ID:1 Aceess ID:1 Mode : trTCM / ColorAware
CIR(Kbps):1000 CBS(Kbyte):1000 PIR(Kbps):2000 PBS(Kbyte):2000
Action:
Conform : Permit Counter: Enabled
Exceed : Drop Counter: Enabled
Violate : Drop Counter: Disabled
------------------------------------------------------------------------------
Profile ID:1 Aceess ID:2 Mode : srTCM / ColorBlind
CIR(Kbps):1000 CBS(Kbyte):100 EBS(Kbyte):200
Action:
Conform : Permit Counter: Enabled
Exceed : Permit Replace DSCP: 60 Counter: Enabled
Violate : Drop Counter: Disabled
------------------------------------------------------------------------------
Total Entries: 2
DGS-3120-24TC:admin#
7-8 create port_group
Description
This command is used to create a port group.
Format
create port_group id <value 1-64> name <name 16>
Parameters
id - Specify the port group ID.
<value 1-64>
- Enter the port group ID here. This value must be between 1 and 64.
name - Specify the port group name.
<name 16> - Enter the port group name here. This name can be up to 16 characters long.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To create a port group: