xStack
®
DGS-3120 Series Managed Switch CLI Reference Guide
363
34-18 debug address_binding
Description
This command is used to start the IMPB debug when the IMPB module receives an ARP/IP packet
or a DHCP packet.
Format
debug address_binding [event | dhcp | all] state [enable | disable]
Parameters
event - To print out the debug messages when IMPB module receives ARP/IP packets.
dhcp - To print out the debug messages when the IMPB module receives the DHCP packets.
- Print out all debug messages.
state - This parameter configures the IMPB debug state to be enabled or disabled.
enable - Specify that the state will be enabled.
disable - Specify that the state will be disabled.
Restrictions
Only Administrator users can issue this command.
Example
To print out all debug IMPB messages:
DGS-3120-24TC:admin# debug address_binding all state enable
Command: debug address_binding all state enable
Success.
DGS-3120-24TC:admin#
34-19 no debug address_binding
Description
This command is used to stop the IMPB debug starting when the IMPB module receives an
ARP/IP packet or a DHCP packet.
Format
no debug address_binding
Parameters
None.
Restrictions
Only Administrator users can issue this command.
To Next Page
Loading...
