DGS-3130 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
130
After clicking the Add Rule button next to an IPv6 type profile, the following page will appear.
Figure 5-44 VLAN Mapping Profile (IPv6, Add Rule) Window
The fields that can be configured are described below:
Parameter Description
Rule ID
Enter the VLAN mapping rule ID here. If not specified, the rule ID begins from
10 and is incremented by 10 for every new rule. The range is from 1 to 10000
Src-IPv6 Address Enter the source IPv6 address and prefix length here.
Dst-IPv6 Address Enter the destination IPv6 address and prefix length here.
Action Select the action that will be taken here. Options to choose from are Dot1q-
Tunnel and Translate.
• Dot1q-Tunnel - Specifies that the outer-VID will be added for matched
packets.
• Translate - Specifies that the outer-VID will replace the outer-VID of the
matched packets.
New Outer VID Enter the new outer VLAN ID here. The range is from 1 to 4094.
802.1P Priority Select the 802.1p priority value here. The range is from 0 to 7. A higher value
has a higher priority.
New Inner VID
After selecting Dot1q-Tunnel as the action, enter the new inner VLAN ID here.
The range is from 1 to 4094. This option is only available when Dot1q-Tunnel
was selected as the action.
Click the Back button to return to the previous window.
Click the Apply button to accept the changes made.
To Next Page
Loading...
