DGS-3130 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
385
Click the Apply button to accept the changes made.
The fields that can be configured in Clear CFM DM are described below:
Parameter Description
Type Select the type of information to clear here. Options to choose from are:
• Result - Specifies to clear the stored DM results.
• Statistics - Specifies to clear the stored statistics of ETH-DM frames
(DMM and DMR).
Click the Clear button to clear the CFM DM statistics information based on the selection made.
Click the Clear All button to clear all the CFM DM statistics information.
Click the Back button to return to the previous window.
After clicking the Edit LM button, the following page will appear.
Figure 10-11 CFM Settings (Add MA, Add MEP, Edit LM) Window
The fields that can be configured in CFM LM Settings are described below:
Parameter Description
State Select to enable or disable the ITU Y.1731 Loss Measurement (LM) feature
here. When the administrative state of frame loss measurement function is
enabled on an MEP, the MEP will maintain the counters of frame loss
measurement function, and can reply LMR messages when receiving LMM
messages.
Click the Apply button to accept the changes made.
The fields that can be configured in CFM LM Test are described below:
Parameter Description
MAC Address Enter the MAC address for the LM test here.
To Next Page
Loading...
