DGS-3130 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
52
To view the following window, click Management > DHCP > DHCP Server > DHCP Server Global Settings, as
shown below:
Figure 4-28 DHCP Server Global Settings Window
The fields that can be configured in DHCP Use Class State are described below:
Parameter Description
DHCP Use Class State Select to enable or disable the DHCP Use Class State here. When enabled, the
DHCP server will use DHCP classes for address allocation.
Click the Apply button to accept the changes made.
The fields that can be configured in DHCP Server Settings are described below:
Parameter Description
DHCP Ping Packet Enter the number of ping packets that the Switch will send out on the network
containing the IP address to be allotted. If the ping request is not returned, the
IP address is considered unique to the local network and then allotted to the
requesting client. A value of 0 means there is no ping test. The range is from 0
to 10. The default value is 2.
DHCP Ping Timeout Enter the amount of time the DHCP server must wait before timing out a ping
packet. The range is from 100 to 10000 milliseconds. The default value is 500
milliseconds.
Click the Apply button to accept the changes made.
DHCP Server Pool Settings
This window is used to display and configure the DHCP server pool settings.
To view the following window, click Management > DHCP > DHCP Server > DHCP Server Pool Settings, as shown
below:
Figure 4-29 DHCP Server Pool Settings Window
To Next Page
Loading...
