D-Link DGS-3200 SERIES - Config Log_Save_Timing; Show Log_Save_Timing

DGS-3200 Series Layer 2 Gigabit Managed Switch CLI Manual
104
DGS-3200-10:4#
8-14 config log_save_timing
Purpose
Used to configure the method to save log.
Format
config log_save_timing [time_interval <min 1-65535> | on_demand | log_trigger]
Description
The config log_save_timing command is used to set the method to save log.
Parameters
Parameters Description
time_interval
Save log to flash every xxx minutes. (if no log happen in this
period, don't save)
on_demand
Save log to flash whener user type "save log" or "save all".
log_trigger
Save log to flash whenever log arrives.
Restrictions
You must have administrator privileges.
Notes
The default method is on_demand.
Examples
To configure method to save log as on demand:
DGS-3200-10:4# config log_save_timing on_demand
Command: config log_save_timing on_demand
Success.
DGS-3200-10:4#
8-15 show log_save_timing
Purpose
Used to show the method to save log.
Format
show log_save_timing