D-Link DGS-3200 SERIES - Reconfig; Config Sim_Group

DGS-3200 Series Layer 2 Gigabit Managed Switch CLI Manual
131
Total Entries: 3
DGS-3200-10:4#
14-4 reconfig
Purpose
Used to re-Telnet to member.
Format
reconfig { member_id <value 1-32> | exit }
Description
The reconfig command is used to re-Telnet to a member.
Parameters
Parameters Description
member_id
Specifies the serial number of a member.
Restrictions
You must have administrator privilege.
Examples
To re-Telnet to a member:
DGS-3200-10:4#reconfig member_id 1
Command: reconfig member_id 1
DGS-3200-10:4#
Login:
14-5 config sim_group
Purpose
Used to configure group information.
Format
config sim_group [ add <candidate_id 1-100> { <password> } | delete <member_id 1-32> ]
Description
The config sim_group command configures group information on the switch.