D-Link DGS-3200 SERIES - Config Stp Mst_Config_Id

DGS-3200 Series Layer 2 Gigabit Managed Switch CLI Manual
148
DGS-3200-10:4# config stp instance_id 2 add_vlan 1 to 3
Command: config stp instance_id 2 add_vlan 1 to 3
Success.
DGS-3200-10:4#
To remove a VLAN ID from an MSTP instance:
DGS-3200-10:4# config stp instance_id 2 remove_vlan 2
Command: config stp instance_id 2 remove_vlan 2
Success.
DGS-3200-10:4#
16-8 config stp mst_config_id
Purpose
Used to change the name or revision level of the MST configuration identification.
Format
config stp mst_config_id { name <string> | revision_level <int> }
Description
To configure a configuration name or revision level in the MST configuration identification. The default
configuration name is the MAC address of the bridge.
Parameters
Parameters Description
name
The name given for a specified MST region.
revision_level
The same given name with a different revision level also represents a
different MST region.
Restrictions
You must have administrator privilege.
Examples
To change the name and revision level of the MST configuration identification: