D-Link DGS-3200 SERIES - Show Dot1 V_Protocol_Group; Config Port Dot1 V

DGS-3200 Series Layer 2 Gigabit Managed Switch CLI Manual
189
Parameters Description
group_id
Specifies the group ID to be deleted.
group_name
The name of the protocol group.
Restrictions
You must have administrator privileges.
21-5 show dot1v_protocol_group
Purpose
Display the protocols defined in a protocol group.
Format
show dot1v_protocol_group {group_id <id> | group_name <name>}
Description
Display the protocols defined in protocol groups.
Parameters
Parameters Description
group_id
Specifies the ID of the group to be displayed if group id is not specified,
all configured protocol groups will be displayed
group_name
The name of the protocol group.
Restrictions
None.
21-6 config port dot1v
Purpose
Assign the VLAN for untagged packets ingress from the portlist based on the protocol group configured.
Format
config port dot1v ports [<portlist> | all] [add protocol_group [group_id <id>| group_name <name>]
[vlan < vlan_name 32> | vlanid <vlanid>] {priority <value 0-7>} | delete protocol_group [group_id
<id>|all]]
Description
Assign the VLAN for untagged packets ingress from the portlist based on the protocol group configured.
This assignment can be removed by using the delete protocol_group option.
When priority is not specified in the command, the port default prority will be the priority for those untagged
packets classified by the protocol VLAN.