D-Link DGS-3200 SERIES - 23 Lacp Configuration Command List; Config Lacp_Ports; Show Lacp_Ports

DGS-3200 Series Layer 2 Gigabit Managed Switch CLI Manual
196
23 LACP Configuration Command List
config lacp_ports <portlist> mode [active|passive]
show lacp_ports {<portlist>}
23-1 config lacp_ports
Purpose
Configure current mode of LACP of port .
Format
config lacp_ports <portlist> mode [active|passive]
Description
The config lacp command config per-port LACP mode.
Parameters
Parameters Description
portlist
Specified a range of ports to be configured.
mode active/passive
If no parameter is specified, the system will display current LACP and
all port status.
Restrictions
You must have administrator privileges.
Example
To config port LACP mode:
DGS-3200-10:4#config lacp_port 1-10 mode active
Command: config lacp_port 1-10 mode active
Success.
DGS-3200-10:4#
23-2 show lacp_ports
Purpose
Show current mode of LACP of port(s).
Format
show lacp_ports <portlist>