D-Link DGS-3200 SERIES - Download Firmware; Reboot System

DGS-3200 Series Layer 2 Gigabit Managed Switch CLI Manual
227
Examples
To configure the ARP aging time:
DGS-3200-10:4#config arp_aging time 30
Command: config arp_aging time 30
Success.
DGS-3200-10:4#
30-5 show arpentry
Purpose
Used to display the ARP table.
Format
show arpentry {ipif <ipif_name 12> | ipaddress <ipaddr> | static}
Description
The show arpentry command displays the Address Resolution Protocol (ARP) table. You can filter the
display by IP address, Interface name, or static entries.
Parameters
Parameters Description
ipif_name
The name of the IP interface the end node or station for which the
ARP table entry was made, resides on.
ipaddr
The IP address of the end node or station.
static
Displays the static entries to the ARP table.
If no parameter is specified, all ARP entries will be displayed.
Restrictions
None.
Examples
To display the ARP table: