D-Link DGS-3200 SERIES - Config Igmp_Snooping Querier

DGS-3200 Series Layer 2 Gigabit Managed Switch CLI Manual
237
switch’s can be a member of a multicast group without the switch
receiving a host membership report. The default is 260 seconds.
leave_timer
Leave timer. The default setting is 2.
state
Enable or disable IGMP snooping for the chosen VLAN.
fast_leave
Enable or disable IGMP snooping fast_leave function.
If enable, the membership is immediately removed when the system
receive the IGMP leave message.
Restrictions
You must have administrator privileges.
Examples
To configure the IGMP snooping:
DGS-3200-10:4#config igmp_snooping default host_timeout 250 state enable
Command: config igmp_snooping default host_timeout 250 state enable fast
_
leave
enable
Success.
DGS-3200-10:4#
32-2 config igmp_snooping querier
Purpose
Used to configure the the time in seconds between general query transmissions, the maximum time in
seconds to wait for reports from members, the permitted packet loss that guarantees IGMP snooping.
Format
config igmp_snooping querier [ vlan_name <vlan_name 32>| vlanid <vlanid_list> |all]
{ query_interval <sec 1-65535> | max_response_time <sec 1-25> | robustness_variable <value
1-255> | last_member_query_interval <sec 1-25> | state [enable|disable] version <value 1-3> }
Description
The config igmp_snooping querier command configures IGMP snooping querier.
Parameters
Parameters Description
vlan_name
The name of the VLAN for which IGMP snooping querier is to be
configured.