D-Link DGS-3200 SERIES - Config Mld_Snooping Mrouter_Ports; Config Mld_Snooping Mrouter_Ports_Forbidden

DGS-3200 Series Layer 2 Gigabit Managed Switch CLI Manual
249
DGS-3200-10:4#config mld_snooping querier default query_interval 125 state enable
Command: config mld_snooping querier default query_interval 125 state enable
Success.
DGS-3200-10:4#
33-3 config mld_snooping mrouter_ports
Purpose
Used to configure ports as router ports.
Format
config mld_snooping mrouter_ports <vlan_name 32> [add|delete] <portlist>
Description
The config mld_snooping mrouter_ports command allows you to designate a range of ports as being
connected to multicast-enabled routers. This will ensure that all packets with such a router as its
destination will reach the multicast-enabled router − regardless of protocol, etc.
Parameters
Parameters Description
vlan_name
The name of the VLAN on which the router port resides.
add | delete
Specifies to add or delete the router ports.
portlist
Specifies a range of ports to be configured. (UnitID:port number)
Restrictions
You must have administrator privileges.
Example
To set up static router ports:
DGS-3200-10:4#config mld_snooping mrouter_ports default add 1-10
Command: config mld_snooping mrouter_ports default add 1-10
Success.
DGS-3200-10:4#
33-4 config mld_snooping mrouter_ports_forbidden
Purpose
Used to configure ports as forbidden router ports.