D-Link DGS-3200 SERIES - Config 802.1 X Auth_Mode; Config 802.1 X Init

DGS-3200 Series Layer 2 Gigabit Managed Switch CLI Manual
274
Examples
To configure the parameters that control the operation of the authenticator associated with a port:
DGS-3200-10:4# config 802.1x auth_parameter ports 1:1-1:20 direction both
Command: config 802.1x auth_parameter ports 1:1-1:20 direction both
Success.
DGS-3200-10:4#
35-10 config 802.1x auth_mode
Purpose
Used to configure 802.1x authentication mode.
Format
config 802.1x auth_mode [port_based |mac_based]
Description
The config 802.1x auth_mode command configures the authentication mode.
Parameters
Parameters Description
port_based
Configure the authentication as port-based mode.
mac_based
Configure the authentication as MAC-based mode.
Restrictions
You must have administrator privileges.
Examples
To configure the authentication mode.:
DGS-3200-10:4#config 802.1x auth_mode port_based
Command: config 802.1x auth_mode port_based
Success.
DGS-3200-10:4#
35-11 config 802.1x init
Purpose
Used to initialize the authentication state machine of some or all ports.