DGS-3200 Series Layer 2 Gigabit Managed Switch CLI Manual
278
35-15 config 802.1x guest vlan
Purpose
Used to configure a guest VLAN setting.
Format
config 802.1x guest_vlan ports [<portlist>|all] state [enable | disable]
Description
The config guest vlan command will config a guest VLAN setting.
Parameter
Parameters Description
ports
A range of ports to enable or disable the guest VLAN function
state
Specify the guest VLAN port state of the configured ports.
enable: join to the guest VLAN.
disable: remove from guest VLAN.
Restrictions
You must have administrator privileges. If the specific port state is changed from the enabled state to the
disabled state, this port will move to its original VLAN.
Example
DGS-3200-10:4#
config 802.1x guest_vlan ports 1-8 state enable
Command:
config 802.1x guest_vlan ports 1-8 state enable
Warning! GVRP of the ports were disable !
Success.
DGS-3200-10:4#
35-16 show 802.1x guest vlan
Purpose
Used to show the guest VLAN setting.
Format
show 802.1x guest _vlan
To Next Page
Loading...
