D-Link DGS-3200 SERIES - Config Authen Parameter Attempt; Show Authen Parameter

DGS-3200 Series Layer 2 Gigabit Managed Switch CLI Manual
313
36-23 config authen parameter attempt
Purpose
Used to configure the maximum attempts for users trying to login or promote the privilege on console,
Telnet, or SSH applications.
Format
config authen parameter attempt <int 1-255>
Description
Used to configure the maximum attempts for users trying to login or promote the privilege on console,
Telnet, or SSH applications. If the failure value is exceeded, connection or access will be locked.
Parameters
Parameters Description
<int 1-255>
The amount of attempts for users trying to login or promote the
privilege on console, Telnet, or SSH. The default value is 3.
Restrictions
You must have administrator privilege.
Examples
To configure the maximum attempts for users trying to login or promote the privilege to be 9:
DGS-3200-10:4#config authen parameter attempt 9
Command: config authen parameter attempt 9
Success.
DGS-3200-10:4#
36-24 show authen parameter
Purpose
Used to display the parameters of authentication.
Format
show authen parameter
Description
Display the parameters of authentication.