D-Link DGS-3200 SERIES - Config Jwac Port

DGS-3200 Series Layer 2 Gigabit Managed Switch CLI Manual
370
DGS-3200-10:4#
42-13 config jwac port
Purpose
Used to configure the port state of JWAC.
Format
config jwac port [<portlist> | all] {state [enable | disable] | max_authenticating_host <value 0-10> |
aging_time [infinite | <min 1-1440>] | idle_time [infinite | <min 1-1440>] | block_time [<sec 0-300>]}
Description
The config jwac port command allows you to configure port state of JWAC. The default value of the
max_authenticating_host is 10. The default value of the aging_time is 1440 minutes. The default value
of the idle_time is infinite. The default value of the block_time is 0 seconds.
Parameters
Parameters Description
<porlist>
A port range for setting the JWAC state.
all
Every Switch ports’ JWAC state is configured.
state
Specifies the port state of JWAC.
max_authenticating_host
The maximum number of hosts that can process authentication
on each port at the same time.
aging_time
A time period during which an authenticated host will keep in
authenticated state. “infinite” indicates never aging out the
authenticated host on the port.
idle_time
If there is no traffic during idle time, the host will be moved back
to unauthenticated state. “infinite” indicates never checking the
idle state of the authenticated host on the port.
block_time
If a host fail to pass the authentication, it will be blocked for a
period specified by the block time.
Restrictions
You must have administrator privileges.
Example
DGS-3200-10:4# config jwac port 1-9 state enable
Command: config jwac port 1-9 state enable
Success.
DGS-3200-10:4#