DGS-3200 Series Layer 2 Gigabit Managed Switch CLI Manual
376
Parameters
Parameters Description
port
A port range to show the information of client host
authenticated
Only to show authenticated client hosts
authenticating
Only to show client hosts being in authenticating process
blocked
Only to show client host being temporarily blocked because of the
failure of authentication.
Restrictions
None.
Example
DGS-3200-10:4# show jwac host port 3
Command: show jwac host port 3
Remaining
Hosts Port VID AgeTime/IdleTime Authentication State
or BlockingTime
----------------- ---- --- ---------------- --------------------
00-00-00-00-00-01 3 5 98 Min/Infinite Authenticated
00-00-00-00-00-02 3 99 Infinite/Infinite Authenticating
00-00-00-00-00-03 2 44 30 Sec Blocked
Total Authenticating Hosts :1
Total Authenticated Hosts :1
Total Blocked Hosts :1
DGS-3200-10:4#
42-21 show jwac port
Purpose
Used to display the port configuration of JWAC.
Format
show jwac port [all | <portlist>]
Description
The show jwac port command allows you to display the port configuration of JWAC.
To Next Page
Loading...
