D-Link DGS-3200 SERIES - Config Scheduling

DGS-3200 Series Layer 2 Gigabit Managed Switch CLI Manual
382
DGS-3200-10:4#show bandwidth_control 1-10
Command: show bandwidth_control 1-10
Bandwidth Control Table
Port RX Rate TX Rate Effective RX Effective TX
(Kbit/sec) (Kbit/sec) (Kbit/sec) (Kbit/sec)
---- ---------- ---------- ---------------- ----------------
1 1024 1024 1024 1024
2 1024 1024 1024 1024
3 1024 1024 1024 1024
4 1024 1024 1024 1024
5 1024 1024 1024 1024
6 no_limit no_limit no_limit no_limit
7 no_limit no_limit no_limit no_limit
8 no_limit no_limit no_limit no_limit
9 no_limit no_limit no_limit no_limit
10 no_limit no_limit no_limit no_limit
DGS-3200-10:4#
43-3 config scheduling
Purpose
Used to configure the traffic scheduling mechanism for each COS queue.
Format
config scheduling <class_id 0-7> max_packet <value 0-255>
Description
The switch contains n+1 hardware priority queues. Incoming packets must be mapped to one of these n+1
queues. This command is used to specify the rotation by which these n+1 hardware priority queues are
emptied.
Parameters